« Previous « Start

9  Starting TOMLAB

When the files are installed and the license is setup correctly, MATLAB can be started. Change directory to the root directory of TOMLAB (where TOMLAB was installed, that is) and run

  >> startup

This command checks the installation and makes sure the license is properly installed. If everything is ok one can start using TOMLAB. If something is wrong, go back and check every step covered in this guide. If that cannot solve your problem, don't hesitate to contact support at support@tomopt.com.

The QUICKSTART GUIDE (available at http://tomopt.com) is good for getting started with TOMLAB.

« Previous « Start